|
In stock
|
Out of stock
|
||
|
|
|||
|
|
|||
The Electro River LiPo 7.4V 2300mAh 20/40C battery is a modern power source for AEG airsoft replicas, combining stable performance, reliability, and everyday practicality. It is suitable for both beginners and experienced players who need dependable operation, safe use, and consistent output in a wide range of conditions.
Its 2300 mAh capacity provides extended operating time on a single charge, which is especially important during long training sessions, skirmishes, or intensive gameplay scenarios. With a continuous discharge rate of 20C and a peak rate of 40C, the battery can reliably power the replica’s internal systems even under increased load.
Special attention has been given to safety and service life. Thanks to NanoSafe® technology, the battery is better protected against overheating and offers a reduced risk of ignition in the event of damage. Additional overcharge and over-discharge protection helps extend battery life and reduces the risk of premature wear.
Subzero Power technology allows the battery to maintain efficient performance even in low-temperature conditions, making it a good choice for winter airsoft use. Its low self-discharge rate helps preserve stored energy over longer periods, so the battery remains ready for use even after extended storage.
Another key advantage is its compact size. Despite its high capacity, the battery remains small enough to fit AEG replicas with limited battery space. High-quality wiring and the Mini-Tamiya connector support efficient power transfer, while the low internal resistance helps make the most of the battery’s energy potential.
LiPo batteries do not suffer from memory effect, so they can be recharged without being fully discharged first. With proper charging, use, and storage, this type of battery can typically handle around 500 to 700 charge cycles.
Specifications:
-
Purpose: for airsoft replicas
-
Type: lithium-polymer battery (LiPo)
-
Voltage: 7.4 V
-
Capacity: 2300 mAh
-
Continuous discharge rate: 20C
-
Peak discharge rate: 40C
-
Connector: Mini-Tamiya
-
Body dimensions: 10 × 1.5 × 3.4 cm
-
Cable length: 10 cm
-
Weight: 106 g
For LiPo and Li-Ion batteries, the warranty only covers switching on. The product cannot be returned or exchanged in the future!
Do not allow the battery to discharge below the maximum permissible level (3 V per section), this may cause damage, and in some cases, fire. An unused battery must be charged to 70%.
When using, it is also important not to allow overcharging above 4.2 V per section. The battery must be charged at room temperature. To maintain performance when charging, you must use balancing when connecting.
Do not allow the battery to completely discharge!
Do not store the battery at temperatures below 0 °C.
Do not use the machine at temperatures below -1 °C.