In stock
|
Out of stock
|
||
|
HackRF is a unique device designed to test and develop modern radio technologies. HackRF One is an open hardware platform that can be used as a USB peripheral or programmed to operate autonomously.
The device allows not only to receive, but also to transmit radio signals in the range of 1MHz-6GHz with a bandwidth of up to 20MHz. Supported sample rates: 2 to 20 msec / s.
The HackRf One has 2 buttons: Reset - to reboot the HackRf by power, and DFU - to restore the factory firmware. The HackRf One has an SMA antenna connector.
On the other side there is a micro-USB connector and two SMA connectors signed as CLKIN and CLKOUT. This is the input and output for synchronization. They can be used both to synchronize the operation of several HackRf with each other, and to synchronize with other signal sources.
Software controlled antenna port power supply up to 50mA @ 3.3V.
The end user is responsible for the legal use of HackRF One. Before applying power, you must install the antenna, and only then connect the power cable.
Resolution: 8 bit
Interface: high speed usb (with micro-b usb connector)
SMA female antenna connector (50 ohm)
SMA clock input and output for synchronization
Convenient buttons for programming
USB powered