Nova Poshta & 
Ukrposhta.
|
In stock
|
Out of stock
|
||
|
|
|||
|
|
|||
Specna Arms SA-B02 ONE Kestrel ETU Strikeball Rifle is positioned as a product with very high-quality manufacturing and precise parts fit. In addition, the weight balance is optimized as much as possible, making the rifle very maneuverable and its weight “almost imperceptible when held in a fighting position.”
The SA-B02 is made of metal, plastic, and steel (all screws, pins and tactical suspension grip are steel). The SF-type flask and pistol grip are made of polymer plastic, and the replica body and RIS rail assembly are anodized. The rifle itself is painted using a powder process after sandblasting the surface. This provides significantly higher than usual abrasion resistance of the applied paint.
One of the rifle's design features is the ECS (Enter & Convert™) quick spring change system. This system allows you to customize your rifle to the specifics of a particular range, even without access to a workshop or special tools: simply remove the airbox, and the spring can be replaced in seconds.
The rifle is fully adapted for Li-Po and Li-Fe batteries (BATTERY AND CHARGER NOT INCLUDED). With a base initial discharge rate of ~90 m/s, the replica is ideal for mid-range shooting. The kit also includes an M90-type spring that reduces the muzzle velocity, making the replica ideal for short-range or indoor shooting.
The replica is equipped with Eshooter's Kestrel V2 Basic ETU module. It is characterized by its ease of use and functionality. It is programmable via trigger pull, works with both brush and brushless motors in High Speed and High Torque configurations, enhances the reliability of the replica, and protects internal parts in the event of overload due to motor damage or battery drain.
Kestrel V2 Basic ETU features:
Pre-ignition programmed for 5 stages with piston position learning function (function requires several single shots after connecting the battery for calibration),
Active Break – the replica performs a full cycle with each shot, so no unnecessary overload is created in the gearbox due to part of the cycle being performed;
Locked Rotor Protection – this feature protects the inside of the replica in the event of motor damage;
Battery Drain Protection – Battery drain protection. The motor vibrates and the blue LED lights up five times to indicate a low battery;
Low/High Voltage Protection – the module detects the number of battery cells and adjusts operation to different cell counts and voltages from 6V to 17V.
The SA-B02 is equipped with a 22mm RIS-type rear rail, a set of RIS-type front rails, and an adjustable buttstock with adjustable hold down. The upper receiver rail is fitted with mechanical flip-up sights. For greater realism, the carbine is equipped with a functioning magazine release.
Thanks to the retractable stock with a non-slip footrest, the length of the replica can be adjusted according to the shooter's build and preferences. The discharging device is mounted on a 14mm left-hand thread, which allows you to install a silencer in its place.
Specifications
Initial velocity (m/s): 90
Gearbox Version: v2 modified
Gearbox bearing diameter: 8 mm
Hop-Up: Adjustable
Length: 78.5 cm
Internal barrel length: 290 mm
Barrel threads: 14 mm, CCW
Quick spring change: yes
Materials: zinc-aluminum alloy, steel, plastic
Weight: 2550 g/90 oz
Plug: DEANS/T-connect
Magazine type: hopper
Magazine capacity: 300 bullets
Accessories: drive, Hi-Cap magazine for 300 bullets, mechanical sights, replaceable M90 firing spring.