In stock
|
Out of stock
|
||
|
A kit from Otis containing two popular items in one handy package. A must-have for any Glock owner, this kit includes an 8-in-1 T-tool for the pistol and a Glock magazine plate disassembly tool, both designed and made in the USA.
Otis 8-in-1 Pistol T-Tool Multitool
The small but powerful Otis 8-in-1 Pistol Tool is designed to service Glock pistols. Easily fits in a pocket, pouch or pistol case.
The main handle has four different uses:
- 1/4” bit driver;
- 8-32 threaded insert for attaching additional components such as rods;
- Memory-Flex cable slot for use as a T-handle;
- punch hammer for resetting pins.
The tool also contains four bits that fit into a magnetic driver on the handle or any other bit driver:
- front site adjustment tool is magnetized for ease of installing front sight screw;
- longer length pin punch to fully push takedown pins through the frame;
- 5/32” flat head;
- #0 Philips bit.
Tool dimensions: 85 x 30 x 15 mm / 3.3 x 1.2 x 0.6 in
Magazine Plate Disassembly Tool For Glock
Safely and easily remove the magazine plate on Glock magazines for proper cleaning, maintenance and inspection. This tool removes the base plate in order to change out or replace springs. Works with standard Glock magazines and won’t damage the plate or magazine body.
Warning! Not suitable for use with Glock 30 round magazines or extended type base plates.
Instructions for use
1. Holding the magazine body with one hand, insert the post into the hole in the bottom of the magazine base plate with the other hand.
2. Place your thumb on the top of the magazine base plate to capture spring. Always keep the magazine in a safe direction.
3. Rotate wrist down. Make sure your thumb stops the magazine spring from launching out of the magazine body. Continue to push the base plate off the magazine body.
Tool dimensions: 130 mm x 45 mm x 10 mm / 5.1 x 1.8 x 0.4 in